Getting Thermal Management Right in Biosensor Fabrication If you’re building biosensors, you know the drill: curing and drying your substrates...

Keeping Your UHP Heater Lamps from Blowing Up Your Budget UHP heater lamps live in a brutal environment. They deal with insane amounts of heat and...

Getting the Heat Right in Biosensor Fabrication Making biosensors is a bit of a balancing act. You need a quick, intense burst of heat to cure your...

Keeping Your Curing Lamps Safe in Chemical Zones Let’s be honest: putting an infrared heater inside a chemical cleaning chamber is a bit like playing...

Keeping Your Class 100 Cleanroom Actually Clean Let’s be honest: heating things up in a Class 100 cleanroom is a nightmare. One tiny flake of oxide...

Keeping Your Ozone-Free IR Lamps From Blowing a Fuse Ozone-free infrared lamps are great because they cut out that 185nm emission line. That means no...

Stop Wasting Time Waiting for Your Clean Room Benches to Heat Up If you’ve spent any time in semiconductor processing, you know the frustration of...

Stop Waiting on Your Rinse Cycle: IR vs. Hot Air If you’ve spent any time in a semiconductor shop, you know the rinse stage is usually where...

Cutting Carbon in the Fab: A Smarter Way to Heat If you’re trying to hit carbon neutrality in a semiconductor fab, you have to talk about heat....

The Problem: Keeping Your Heat Source Spotless Picture this: you’re in a Class 100 cleanroom. The kind of place where a single speck of dust...

On the fab floor, one out-of-spec bake is all it takes to scrap a whole lot. Temperature uniformity, cleanroom particle count, and repeatability...

On the fab floor, you measure the margin for error in photoresist processing in nanometers. A few degrees off during soft bake or hard bake is enough...

On the fab floor, SiC wafers don’t give you any room to play with temperature. A 2°C swing during the photoresist bake is enough to throw overlay...